0  items
$0.00
Saturday October 21, 2017

Pendude Refill Instructions

Slimline Pen

Pull pen body sections apart at center ring. Unscrew (counterclockwise) ink refill from lower pen body. Insert new Cross® style ballpoint refill and screw in (clockwise) finger tight. Push pen body sections together.

 

Slimline Pencil

Pull off pencil click cap. Pull out eraser. Insert 1 to 5 pieces of 0.7mm lead. Replace eraser. Replace click cap.

 

Classic Pen

Unscrew (counterclockwise) upper pen body from lower pen body. Remove ink refill (do not lose the spring). Put spring on new Parker® style ballpoint refill. Insert refill into lower pen body. Screw (clockwise) pen body sections together.

 

Classic Pencil

Pull the pencil halves apart. Unscrew the tip from the nose piece. Turn the pencil mechanism clockwise until the guide pin is exposed at the end of the tip. Back up the mechanism enough to pull the guide pin back inside the sleeve about 1/16". Insert the new 0.7mm lead in the hole and twist the mechanism counterclockwise to retract the lead. Reassemble the pencil.

 

Classic Rollerball Pen

Unscrew pen tip assembly. Remove old ink refill and spring. Drop spring into pen body first, then insert a new Rollerball refill. Place tip assembly over point of refill and screw on snugly.

 

Classic Fountain Pen

Unscrew pen tip assembly. Pull off old ink cartrige. Push on a new ink cartrige with enough pressure to pierce the ink cartrige. Reassemble the pen.

 

Designer Pen

Pull apart the pen halves. Unscrew the old ink refill. Insert a new Cross® style ballpoint refill and screw in finger tight. Reassemble the pen.

 

Designer Pencil

Unscrew the pencil tip and remove lower pencil body section. While holding the corrigated end of the pencil mechanism, twist the mechanism clockwise until gripper and pilot extend out. Retract until gripper is flush with the thread. Gently push a new 0.7mm lead slightly into gripper. Twist mechanism couterclockwise until lead is fully retracted. Reassemble the pencil.

 

Designer Rollerball Pen

Unscrew pen tip assembly. Remove old ink refill and spring. Drop spring into pen body first, then insert a new rollerball refill. Place tip assembly over point of refill and screw on snugly.

 

Designer Fountain Pen

Unscrew pen tip assembly. Pull off old ink cartrige. Push on a new ink cartrige with enough pressure to pierce the ink cartrige. Reassemble the pen.

 

Comfort Grip Pen

Pull pen halves apart at center ring. unscrew old ink refill. Insert new Cross® style ballpoint refill and screw in finger tight. Reassemble the pen.

 

Comfort Grip Pencil

Pull off pencil click cap. Pull out eraser. Insert 1 to 5 pieces of 0.7mm lead. Replace eraser and click cap.

 

Biggie Pen

Unscrew pen halves. Remove old ink refill. Drop in spring and new Parker® style ballpoint refill. Reassemble the pen.

 

POWER Pen

Unscrew pen tip assembly. Remove ink refill (do not lose the spring). Put spring on new Parker® style ballpoint refill. Insert refill into lower pen body. Reassemble pen.

 

POWER Pencil

Press and hold the plunger to remove any remaining lead pieces. Hold plunger and insert new 2.0mm lead through pencil tip.

 

Back